Xiaoxian Ruiyi Commercial Trade Co., Limited
Payment & Shipping Terms:
|Material:||SPCC, DC01||Grade:||DIN EN 10130 10209 DIN 1623|
ASTM A1008 Cold Rolled Steel Coil,
Oil Drum Cold Rolled Steel Coil,
CRC Steel Plate Coil
Cold rolled coil is produced by pickling hot-rolled coil and rolling it uniformly at an appropriated temperature to a thinner thickness. It has excellent surface configuration and superb mechanical properties for use in automobile and electronic appliance production.
DC01 steel (1.0330 material) is a European standard cold-rolled quality low-carbon steel flat product for cold forming. … In addition, this steel is also used under electrogalvanizing conditions. The designation of the steel is DC01+ZE (or 1.0330+ZE), and the standard is EN 10152
Cold rolled steel is also part of our product portfolio. Cold rolled steel is excellent for cold forming. This product group assigned the grades DC01 to DC07, DC01EK to DC06EK, DC03ED to DC06ED and S215G to S325G.
The grades are classified according to the maximum permissible yield strength and can be subdivided as follows.
DC01 – This grade can be used for simple forming work, for example Bending, embossing, beading and pulling are used.
DC03 – This grade is suitable for forming requirements such as Deep drawing and difficult profiles suitable.
DC04 – This quality is suitable for high deformation requirements.
DC05 – This thermoforming grade is suitable for higher forming requirements.
DC06 – This special deep drawing quality is suitable for the highest deformation requirements.
DC07 – This super deep drawing quality is suitable for extreme deformation requirements.
The steel grades DC01EK, DC04EK and DC06EK are suitable for conventional single-layer or double-layer enamelling.
The steel grades DC06ED, DE04ED and DC06ED are suitable for direct enamelling as well as for enamelling according to the two-layer / one-firing method and for special applications of two-layer enamelling for low-distortion enamelling.
Mistakes such as pores, small grooves, small warts, slight scratches and a slight discoloration that does not affect the ability to reshape and adhere to surface coatings are permitted.
The better side must be free from defects so that the homogeneous appearance of a quality finish or an electrolytically applied coating is not impaired. The other side must at least meet the requirements of surface type A.
The surface finish may be particularly smooth, dull or rough. If no details are given when ordering, the surface finish will be delivered in a matt finish. The four surface finishes listed correspond to the center roughness values in the following table and must be tested in accordance with EN 10049.
Professional Plain Aluminum Sheet 2024 Aluminum Sheet For Aircraft Tank
3105 H14 Aluminium Alloy Plate 20 mm -1500 mm Width For Curtain Exterior Decoration
Plain 3003 Aluminium Alloy Plate / Aluminum Roofing Coil For Trailer
Lightweight Diamond Metal Sheet 6061 T6 Aluminum Plate With 1.6mm - 6.0mm Thickness
Brite Finish Aluminum Diamond Plate 12" X 36" Length Custom For Truck Floor
1050 Aluminum Sheet Aluminium Floor Plate With Thickness Customized
Shiny Bright Finish Aluminum Sheet 3003 5 Bar Tread Aluminum Plate
5052 3003 Aluminium Chequered Plate Fire Resistance Leaf Pattern For Solar Reflective Film
High Strength Marine Grade Aluminium Chequered Plate 5086 Aluminium Flat Sheet